Testing Services

No matter where your product is in its life-cycle, PSC is prepared to help. In every case, we are committed to getting you through the entire certification in the least time and for the least expense.

Preliminary Design Review We evaluate drawings, schematics, and/or a product’s construction for the purpose of compliance with established standards and assist in finalizing the design. We work with clients to determine the appropriate standard(s) to which your product will be evaluated and tested, provide recommendations on component selection, establish guidelines for meeting the requirements, and other common issues. We then develop a set of recommendations on how to proceed through the certification process in the shortest time, and for the least cost.

Construction Evaluation If you already have a prototype, or have a product that has not yet been evaluated to the standard you need, we conduct a thorough examination of a product’s construction by going through the relevant standard(s) clause-by-clause. We then produce a detailed report that documents non-compliance’s and provides specific solutions for each one. Based on this information, we confirm the correct testing regime and prepare the product for testing.

Testing Capabilities and Data Acceptance We are fully qualified to conduct a wide range of testing necessary for most US and European standards. If we do not have equipment on site to perform a specific test, we can arrange the procurement of the necessary equipment on a rental or lease basis. All testing is done on NIST-calibrated equipment and in appropriately controlled environments.

Submittal Management  We offer complete project management of the submittal of a product to the NRTL, from submittal until certification is issued. We will work to resolve any and all issues that arise as part of this process. In the event that you elect to have the NRTL conduct testing, and the product fails a test, we will work with you and the NRTL to fully document each non-compliance. We will then provide specific recommendations for how to bring the product into compliance, and make a re-submittal.

Field Evaluations  If your product is already installed in the field, we can evaluate and test it in order to provide certification for a specific instance of installation, rather than certification for the entire production of a product, for compliance to the applicable requirements of the National Electric Code (NEC) and the relevant local Authority Having Jurisdiction (AHJ). If the product(s) is (are) in compliance, we will confirm with the inspector and issue a report. Depending on which NRTL is being used for certification, we can even apply a label to the product upon completion of our evaluation.